MOBO TOT & TOTAL TOT ASSEMBLY INSTRUCTIONS

Steps for assembling Mobo TOT & Total TOT:

  • Step A:

    • Remove nut from wheel bolt.

  • Step B:

    • Insert wheel into rear frame and attach nut.

  • Step C:

    • Tighten using wrenches.
    • Repeat on other side.

  • Step D:

    • For models WITH push bar, tighten bolt only using allen wrench. Do not attach nut.
    • For models WITHOUT push bar, tighten bolt and nut using wrenches.

  • Step E:

    • Remove nut from wheel bolt.

  • Step F:

    • Remove screws from linkage steering and align the linkage steering to the steering arms.
    • Attach screws and nut and tighten.

  • Step G:

    • (* For seat belt only - If your model does not have a seat belt, skip to Step J)
    • Align bottom of seat belt to the bottom of seat.

  • Step H:

    • (* For seat belt only)
    • Tighten screw.

  • Step I:

    • (* For seat belt only)
    • Wrap velcro on top of seat belt around the handle at top of seat.

  • Step J:

    • Place screws and washer in seat onto frame.

  • Step K:

    • Tighten nut onto seat screw.

  • Step L:

    • Remove cap from rear frame.

  • Step M:

    • Place fender and replace cap.

  • Step N:

    • Tighten cap and repeat on other side.

  • Step O:

    • Adjust length to fit rider by loosening quick release lever and pulling out the knob and moving the frame.
    • Tighten lever once adjusted.

  • Step P:

    • (* For push bar only)
    • Align push bar under rear frame and tighten nut onto bolt.

  • Step Q:

    • (* For push bar only)
    • Adjust push bar to desired height.

  • Step R:

    • (* For foot rest only)
    • Loosen and pull out quick release lever.

  • Step S:

    • (* For foot rest only)
    • Align foot rest onto frame, attach and tighten quick release lever.